Description

Product Description

Extra Length Dock Bumper99in x 12in x 6in (2514.6mm x 304.8mm x 152.4mm)

NOTE: This product is not returnable.

Used on loading docks with dock seals, or where refrigeration or warmth is needed. Loading dock bumper and the dock-seal interact to completely seal the truck to the dock.

Uses/Applications:

• Have unlimited applications in factories, warehouses and docks
• Vehicle impact protection for loading docks
• Projecting above low docks
• Rub rails at the sides of truck wells
• Wall bumpers to protect against fork lift trucks
• Special construction features to accommodate unusual anchoring conditions

Features:

• Tough piles of truck tire material reduce chipping or abrasion, unlike molded rubber, extruded rubber, conveyor belting or wood plank bumpers
• Attractive deep black color enhances a neat, professional architectural look
• Manufactured under pressure exceeding 1,500 lbs. to absorb over 80% of impact force
• Anchor bolts protected by at least 3in of rubber to prevent damage
• Maintenance free

Material:

• 80% recycled material from fabric reinforced rubber pads cut from selected recycled truck tires
• Rubber pads laminated between structural steel angles and secured with 3/4in steel tie rods

Installation:

• Structural mounting angles permit welded installations or provide bolting through steel
• No assembly required

Note:

• 1/4in flat plates may be substituted for one or both angles
• If more anchorage devices are required there is an extra charge for each device
• Drawings are anchorage devices are available

Documentation

• B612-99-A3 - Drawing (321K)